Folsom Gas Line Repair & Installation

Hire a professional plumber! Installing gas lines is not a DIY project unless you are specifically trained and certified. Gas can be extremely dangerous, and improper installation can lead to serious safety hazards. If you’re searching for “How to install gas lines,” it’s a clear indication that you should call a professional.

For professionals, here’s a general overview of how a new gas line, such as for a stove, is installed:

Gather Materials: Ensure you have the right materials, including appropriately sized pipes for the job.
Turn Off the Gas: Before starting any work, turn off the gas supply to avoid leaks and accidents.
Extend Existing Pipes: Use fittings, pipes, and valves to extend the existing gas line to reach the new appliance. Utilize flexible piping where possible for easier installation and adjustments.
Test for Air Tightness: After installation, test the line for air tightness to ensure there are no leaks and the connections are secure.
Safety Check: Once safety is confirmed, turn the gas back on and test the flow to ensure the appliance is functioning correctly.
Remember, working with gas lines requires expertise and caution. Always rely on a professional plumber to handle these installations to ensure safety and compliance with local regulations.

Pressure tests are conducted by licensed professionals to ensure that the correct amount of gas is reaching your home and fixtures. If the pressure is too high, it could pose a serious safety risk by pumping excessive gas into the fixtures.

Here’s an overview of how a pressure test is conducted:

Disconnect the Gas Line: Start by disconnecting the gas line at the meter.
Install the Test Gauge: Position the test gauge as close to the meter as possible. The placement of the gauge may be influenced by your meter’s configuration.
Turn Off Appliance Valves: Ensure all valves at appliances that use gas, such as the water heater and stove, are turned off.
Main Gas Shut Off: If your home has a main gas shut-off valve, ensure it is turned on. The test must cover the entire gas piping system from the meter to the appliance locations.
Pressurize the Gas System: Using the valve on the test gauge, pressurize the gas system. This can be done with an air compressor or a hand pump.
Read the Pressure: The gauge will show the pressure in the gas system. Ensure that the pressure is within the safe range specified for your system.
Performing a pressure test requires expertise and precision. Always rely on a licensed professional to carry out this procedure to ensure safety and compliance with regulations.

When installing gas lines, it’s essential to ensure they are buried at a minimum depth of 2 feet underground. In some cases, service lines may be installed at a depth of 18 inches. However, these guidelines can vary significantly depending on your location. It’s crucial to verify the specific requirements set by your city or state officials before beginning any excavation work. Always consult with local authorities to ensure compliance with all regulations and safety standards.

Ensuring that gas lines are properly grounded is an often overlooked but critical safety measure. According to national codes, homes must have a grounding system that includes a ground rod installed near the electric meter. To ground your gas lines, a bare copper wire is connected from the gas line to this grounding system.

Handling gas lines requires professional expertise due to the potential risks involved. For all your gas line needs, trust the experts at Economy Plumbing Service. Whether it’s repairs or a full line replacement, we ensure your family’s safety with our professional and reliable service.

If gas flows through it, we handle it! Choose Economy Plumbing Service for all your gas line needs.